Installing A Plim - Cisco SRS Series Installation Manual

Installing a PLIM

Warning
Class 1 Laser Product. Statement 113
Warning Because invisible radiation may be emitted from the aperture of the port when no fiber cable is connected,
avoid exposure to radiation and do not stare into open apertures. Statement 125
Caution
Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 281
Warning
For diverging beams, viewing the laser output with certain optical instruments within a distance of 100 mm
may pose an eye hazard. For collimated beams, viewing the laser output with certain optical instruments
designed for use at a distance may pose an eye hazard. Statement 282
Warning Laser radiation. Do not view directly with optical instruments. Class 1M laser product. Statement 283
Installing a PLIM
This section describes how to install a PLIM in the LCC. For more detailed information on PLIMs.
Caution
MSC-140G, FP-140, and LSP line cards should only be paired with 20-port and 14-port 10-GE XFP PLIMs
and 1-port 100-GE CFP PLIMs. The MSC-40 line card should not be paired with 20-port and 14-port 10-GE
XFP PLIMs or 1-port 100-GE CFP PLIMs. The MSC-40 line card can be paired with all previous PLIMs.
See the release notes for details.
A PLIM is paired with a line card through the midplane of the chassis. A PLIM provides the ability to choose
several interfaces (for example, Packet-over-SONET [PoS]). The following figure shows a typical PLIM (in
this case, a 14-port 10-GE XFP PLIM).
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
154
Installing and Removing Line Cards, PLIMs, and Associated Components