Installing A Modular Configuration Power Module - Cisco SRS Series Installation Manual

Installing and Removing Power Components
DETAILED STEPS
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection sockets on the
front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2
Remove the upper grille on the front (PLIM) side of the chassis. For detailed instructions, see Installing and Removing
Exterior Cosmetic Components.
Step 3
Use the screwdriver to loosen the two captive screws securing the alarm module to the power shelf.
Step 4 Loosen by hand the panel fasteners on the alarm module.
Step 5
Carefully slide the alarm module out of the power shelf.
What to do next
After performing this task, install a replacement alarm module (if necessary) and re-install the upper grille on
the front (PLIM) side of the chassis.

Installing a Modular Configuration Power Module

This section describes how to install the AC or DC PMs in the LCC.
Figure 47: Modular Configuration PM
Installing a Modular Configuration Power Module
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
85