Steps - Cisco SRS Series Installation Manual

Installing and Removing Line Cards, PLIMs, and Associated Components

Steps

To remove a damaged pillow block, follow these steps:
SUMMARY STEPS
1. Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
2. Locate the pillow block to be replaced. Use the T10 Torx screwdriver to remove the lower right screw.
(See item number 2 in the following figure.)
3. Remove the lower left screw (located below the pillow block pin). (See item number 3 in the above figure.)
4. Remove the top left screw (located above the pillow block pin). (See item number 4 in in the above figure.)
5. Remove the pillow block and set it aside.
6. Repeat this procedure for the card slot's other pillow block if necessary.
DETAILED STEPS
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection sockets on the
front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2 Locate the pillow block to be replaced. Use the T10 Torx screwdriver to remove the lower right screw. (See item number
2 in the following figure.)
Figure 64: Removing a Pillow Block
Step 3
Remove the lower left screw (located below the pillow block pin). (See item number 3 in the above figure.)
Step 4 Remove the top left screw (located above the pillow block pin). (See item number 4 in in the above figure.)
Step 5
Remove the pillow block and set it aside.
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
Steps
121