Required Tools And Equipment; Steps; Power Up And Power Down A Chassis With Modular Configuration Power - Cisco SRS Series Installation Manual

Installing and Removing Power Components

Required Tools and Equipment

You need the following tools to perform this task:
• ESD-preventive wrist strap

Steps

To remove a PM slot cover from a power shelf, perform the following steps:
SUMMARY STEPS
1. Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
2. Gently pinch the tab on the left side of the PM slot cover to detach the PM slot cover from the PM slot,
as shown in the previous figure.
3. Remove the two tabs on the right side of the PM slot cover from the two holes on the right side of the PM
slot, as shown in the previous figure.
4. Set the PM slot cover aside.
DETAILED STEPS
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection sockets on the
front (PLIM) side of the chassis or a bare metal surface on the chassis.
Step 2 Gently pinch the tab on the left side of the PM slot cover to detach the PM slot cover from the PM slot, as shown in the
previous figure.
Step 3 Remove the two tabs on the right side of the PM slot cover from the two holes on the right side of the PM slot, as shown
in the previous figure.
Step 4
Set the PM slot cover aside.
What to do next
After performing this task, install an AC or DC PM, if necessary
Module) and re-install the upper grille on the front (PLIM) side of the chassis. If you plan to remove the power
shelf completely, you must first remove all of the PM slot covers, PMs, and the alarm module from the power
shelf. See
Module.

Power Up and Power Down a Chassis with Modular Configuration Power

This section describes how to power up and power down a chassis with a modular configuration AC or DC
power shelf. For details on the chassis power systems, see
and DC Power
Most components on the chassis, such as the PMs, alarm modules, and fan trays, can be removed or installed
in the chassis while it is running. Although it is possible to install or remove a power shelf while the chassis
is running, it is recommended to remove power from the chassis completely, if possible, for service protection
and safety.
Removing a Modular Configuration Power Module
Systems.
(Installing a Modular Configuration Power
and Removing a Modular Configuration Alarm
Basic Chassis Power
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
Required Tools and Equipment
Details, AC Power Systems,
91