Unlinking The Scanner; Override Locked Scanner; Out-Of-Range Alarm - Honeywell Voyager 1450g Series User Manual

Locked Link Mode - Single Scanner
If you link a scanner to a base or an Access Point using the Locked Link Mode, other scanners are blocked from being
linked if they are inadvertently placed into the base, or if the Access Point linking bar code is scanned. If you do place
a different scanner into a base, it will charge the scanner, but the scanner will not be linked.
To use a different scanner, you need to unlink the original scanner by scanning the Unlink Scanner bar code. (See
Scanner Modes, page 3-9.)
Open Link Mode - Single Scanner
When newly shipped or defaulted to factory settings, a scanner is not linked to a base or an Access Point. A link is
established when the scanner is placed into a base, or an Access Point linking bar code is scanned. When in Open
Link Mode, a new link is established when a new scanner is placed in the base, or you scan an Access Point linking bar
code. Each time a scanner is placed into a base or scans an Access Point linking bar code, the scanner becomes
linked to the base or Access point and the old scanner is unlinked.

Unlinking the Scanner

If a base or an Access Point has a scanner linked to it, that scanner must be unlinked before a new scanner can be linked.
Once the previous scanner is unlinked, it will no longer communicate with the base or Access Point. To unlink the scanner from
a base or an Access Point, scan the Unlink Scanner bar code below.

Override Locked Scanner

If you need to replace a broken or lost scanner that is linked to a base or an Access Point, scan the Override Locked
Scanner bar code below with a new scanner and place that scanner in the base, or scan the Access Point linking bar code.
The locked link will be overridden; the broken or lost scanner's link with the base or Access Point will be removed, and the
new scanner will be linked.

Out-of-Range Alarm

If your scanner is out range of the base, an alarm sounds from both your base and scanner. If your scanner is out range of an
Access Point, an alarm sounds from just the scanner. The alarm stops when the scanner is moved closer to the base or Access
Point, when the base or Access Point connects to another scanner, or when the alarm duration expires. To activate the alarm
3 - 10
Locked Link Mode
(Single Scanner)
* Open Link Mode
(Single Scanner)
Unlink Scanner
Override Locked Scanner
(Single Scanner)