Unlink The Scanner; Override Locked Scanner; Out-Of-Range Alarm - Honeywell Voyager 147 Series User Manual

To use a different scanner, you need to unlink the original scanner by scanning the
Unlink Scanner barcode. (See
Open Link Mode - Single Scanner
When newly shipped or defaulted to factory settings, a scanner is not linked to a
base or an Access Point. A link is established when the scanner is placed into a
base, or an Access Point linking barcode is scanned. When in Open Link Mode, a
new link is established when a new scanner is placed in the base, or you scan an
Access Point linking barcode. Each time a scanner is placed into a base or scans an
Access Point linking barcode, the scanner becomes linked to the base or Access
point and the old scanner is unlinked.

Unlink the Scanner

If a base or an Access Point has a scanner linked to it, that scanner must be
unlinked before a new scanner can be linked. Once the previous scanner is
unlinked, it will no longer communicate with the base or Access Point. To unlink the
scanner from a base or an Access Point, scan the Unlink Scanner barcode below.

Override Locked Scanner

If you need to replace a broken or lost scanner that is linked to a base or an Access
Point, scan the Override Locked Scanner barcode below with a new scanner and
place that scanner in the base, or scan the Access Point linking barcode. The
locked link will be overridden; the broken or lost scanner's link with the base or
Access Point will be removed, and the new scanner will be linked.

Out-of-Range Alarm

If your scanner is out range of the base, an alarm sounds from both your base and
scanner. If your scanner is out range of an Access Point, an alarm sounds from just
the scanner. The alarm stops when the scanner is moved closer to the base or
50
Scanner Modes.)
* Open Link Mode
(Single Scanner)
Unlink Scanner
Override Locked Scanner
(Single Scanner)
Voyager XP User Guide