Unlink The Scanner; Reading Techniques - Honeywell Enhanced Xenon 1902H Quick Start Manual

Link the Scanner
Use the following procedure to configure all scanners so they auto-
matically connect to the base.
1. Scan the bar code on the base.
2. Place the scanner into the base.
3. Power cycle the base to complete the link and establish
communication between the base and scanner.
When the scanner is in the base, the green LED on the base flashes
to indicate the scanner's battery is charging.

Unlink the Scanner

If the base has a scanner linked to it, that scanner must be unlinked
before a new scanner can be linked. Once the previous scanner is
unlinked, it will no longer communicate with the base. Scan the
Unlink Scanner bar code to unlink a scanner.
Unlink Scanner

Reading Techniques

The view finder projects an aiming
beam that should be centered over
the bar code, but it can be posi-
tioned in any direction for a good
read.
Hold the scanner over the bar code,
pull the trigger, and center the aim-
ing beam on the bar code.