Establishing Community Names - Cabletron Systems DLE52-MA User Manual

Access Policy (Read-Only)
Indicates the access given each community name. Possible selections are
as follows:
read-only
read-write
super-user
5.9.1

Establishing Community Names

The password used to access Local Management at the Password screen
must have Super-User access in order to view and edit the SNMP
Community Names screen. Using a password with read-only or
read-write access does not allow the user to view or edit the SNMP
Community Names screen.
Any community name assigned in the SNMP Community
Names screen is a password to its corresponding level of
access to Local Management. The community name assigned
Super-User access is the only one that gives the user complete
access to Local Management.
All passwords assigned in the DLM6C-AA SNMP Community
Names screen allow access to both the DLM6C-AA Local
Management screens, and the Local Management screens of
the interface modules that are installed in the chassis. To
configure the interface module to disallow access to the
DLM6C-AA Local Management screens refer to Section 6.5.
DLE02-MA/DLE52-MA User's Guide
SNMP Community Names Screen
This community name allows read-only access
to the DLM6C-AA MIB objects, and excludes
access to security-protected fields of read-write
or super-user authorization.
This community name allows read and write
access to the DLM6C-AA MIB objects,
excluding security protected fields for
super-user access only.
This community name permits read-write
access to the DLM6C-AA MIB objects and
allows the user to change all modifiable
parameters including community names, IP
addresses, traps, and SNMP objects.
5-27