Cabletron Systems DLE52-MA User Manual page 59

Table 4-1 LANVIEW LEDs CPU, Receive, and Transmit Status (Continued)
LED Color
TX Off
Green
Amber
Red
Table 4-2 Speed and Full Duplex LED Indications
LED
The following port DPX and SPD LED indications are only valid when the LED
MODE switch is in the DPX-SPD position.
DPX
(Duplex
Status)
SPD (Speed
Status)
DLE02-MA/DLE52-MA User's Guide
State
Port enabled, and no
activity. Should flash
green every two
seconds indicating
BPDUs being sent if
STA is enabled and
there is a valid link.
Flashing. Indicates
activity. Rate indicates
data rate.
Blinking. Port in
standby.
Port may be disabled
due to Spanning Tree.
Flashing. Indicates
collision rate.
Solid. Diagnostic
Failure.
Color
Amber
Green
Amber
Green
Recommended Action
1. Ensure that the STA is
enabled and that there is valid
link. Section 6.16.1 describes
how to enable the STA.
2. Contact your DIGITAL
representative.
None.
1. Ensure that the port is not
disabled. Refer to
Section 6.16.3 for information
on enabling/disabling ports.
2. Contact your DIGITAL
representative.
None, unless there is a high rate
of activity. If so, check for network
configuration problems or a
defective device.
Contact your DIGITAL
representative.
Description
Port is operating in standard mode
(10 Mbps or 100 Mbps).
Port is operating in full duplex mode
(20 Mbps or 200 Mbps).
There is a link and the port is operating at
10 Mbps.
There is a link and the port is operating at
100 Mbps.
Using LANVIEW
4-5