Setting The Ip Address - Cabletron Systems DLE52-MA User Manual

has up to five minutes to respond to each of the specified module's Local
Management screens. In this example, after five minutes of "idleness" (no
input or action), the terminal "beeps" five times, the Local Management
application terminates the session, and the display returns to the Password
screen. To enter a new lockout time, refer to Section 5.8.6.
Chassis Uptime (Read-Only)
Displays the total time the chassis has been operating. The chassis uptime
is based on which interface module installed in the chassis has been
operating for the longest period of time.
Operational Mode (Read-Only)
Displays the 802.1Q SWITCHING option.
With the operational mode set to 802.1Q SWITCHING, the DLE02-MA
and the DLE52-MA act as an IEEE 802.1Q switch. The modules are able
to increase their switching functionality by creating and maintaining port
based Virtual LANs (VLANs).
If the DLE02-MA and the DLE52-MA have been set to 802.1Q
SWITCHING, refer to your Port Based VLAN User's Guide to
configure the devices for this type of operation.
5.8.1

Setting the IP Address

To set the IP address, perform the following steps:
1. Use the arrow keys to highlight the IP Address field.
2. Enter the IP address into this field using Decimal Dotted Notation
(DDN) format (nnn.nnn.nnn.nnn).
3. Press ENTER. If the IP address is a valid format, the cursor returns to
the beginning of the IP address field. If the entry is not valid, the Event
DLE02-MA/DLE52-MA User's Guide
Chassis Configuration Screen
5-21