Accessing Local Management - Cabletron Systems DLE52-MA User Manual

Interface modules
Hide thumbs Also See for DLE52-MA:
Table of Contents

Advertisement

Chapter 5
LM: Overview, Setup, and Chassis Management

display fields are in plain type (not bold). In the field description, the field
is identified as being "read-only".
Input Fields
Input Fields require the entry of keyboard characters. IP addresses,
subnet mask, default gateway and device time are examples of input
fields. In the screens shown in this guide, the characters in the input fields
are in bold type. In the field description, the field is identified as being
"modifiable".
Selection Fields
Selection fields provide a series of possible values. Only applicable values
appear in a selection field. In the screens shown in this guide, the
selections display within brackets and are in bold type. In the field
description, the field is identified as being either "selectable" when there
are more than two possible values, or "toggle" when there are only two
possible values.
Command Fields
Command fields are located at the bottom of Local Management screens.
Command fields are used to exit Local Management screens, save Local
Management entries, or navigate to the next sequence in the same screen.
In the screens shown in this guide, the characters in this field are all
UPPER CASE and in bold type. In the field description, the field is
identified as being a "command" field.
5.5

ACCESSING LOCAL MANAGEMENT

Access to Local Management is controlled through the Password screen,
Figure 5-4. Whenever a connection is made to the DLE02-MA or the
DLE52-MA, the Password screen displays. Before continuing, the user
must enter a password, which is compared to the previously stored
passwords. The level of access allowed the user depends on the password.
To set or change passwords, refer to Section 5.9. The following steps
describe the procedure to access Local Management.
1. Turn on the terminal. Press ENTER (this may take up to four
keystrokes, until the COM port of the DLE02-MA or the DLE52-MA
auto-senses the baud rate of the terminal) until the DLM6C-AA Local
Management Password screen, Figure 5-4, displays.
5-10
DLE02-MA/DLE52-MA User's Guide

Advertisement

Table of Contents
loading

Table of Contents