Installing Options; Installing The Dle02-Ma And The Dle52-Ma Into The Dlm6C-Aa Chassis - Cabletron Systems DLE52-MA User Manual

Chapter 3 Installation
3.2

INSTALLING OPTIONS

If installing an optional HSIM or VHSIM, it must be installed in the
DLE52-MA before proceeding to Section 3.3. Complete instructions for
installing an optional HSIM or VHSIM are available in the applicable
HSIM or VHSIM User's Guide. For details on how to get manuals, refer
to the Related Documentation section in the Preface of this guide. Refer to
Appendix B for the HSIM or VHSIM connector locations.
3.3 INSTALLING THE DLE02-MA AND THE DLE52-MA
INTO THE DLM6C-AA CHASSIS
Failure to observe static safety precautions could cause
!
damage to the DLE02-MA and the DLE52-MA. Follow static
safety handling rules and wear the antistatic wrist strap
provided with the DLM6C-AA chassis.
Do not cut the non-conductive bag to remove the module.
Damage could result from sharp objects contacting the board
or components.
The DLE02-MA and the DLE52-MA can be installed in any of the 5 slots
that are available. To install a module, refer to Figure 3-1 and proceed as
follows:
1. Remove the blank panel covering the slot in which the module will be
installed. All other slots must remain covered to ensure proper airflow
and cooling. (Save the blank plate in the event you need to remove the
module.)
2. Carefully remove the module from the shipping box. (Save the box
and packing materials in the event the module must be reshipped.)
3. Locate the antistatic wrist strap shipped with the DLM6C-AA chassis.
Attach the antistatic wrist strap to your wrist and plug the cable from
the antistatic wrist strap into the ESD grounding receptacle at the
upper right corner of the DLM6C-AA.
4. Remove the module from the plastic bag. (Save the bag in the event
the module must be reshipped.) Observe all precautions to prevent
damage from Electrostatic Discharge (ESD).
3-2 DLE02-MA/DLE52-MA User's Guide