Chapter 2 Network Requirements; Smarttrunk; 10Base-T Network - Cabletron Systems DLE52-MA User Manual

Before installing the DLE02-MA and the DLE52-MA interface modules,
review the requirements and specifications referred to in this chapter
concerning the following:
• SmartTrunk (Section 2.1)
• 10BASE-T Twisted Pair Network (Section 2.2)
• 100BASE-TX Twisted Pair Network (Section 2.3)
The network installation must meet the guidelines in this chapter and in
the documents referenced in this chapter to ensure satisfactory
performance of the equipment. Failure to follow the guidelines may
produce poor network performance.
The Cabletron Systems Cabling Guide , referred to in the
following sections, can be found at
http://www.networks.digital.com.
2.1

SmartTrunk

To connect the DLE02-MA and the DLE52-MA to a network so they can
take advantage of the SmartTrunk feature, there are certain rules
concerning port connections and configurations that must be followed for
proper operation.
Refer to the list of supported features in the releate ntes to determine if
SmartTrunk is supported. For information on SmartTrunk configuration,
refer to the SmartTrunk User's Guide.
2.2

10BASE-T NETWORK

When connecting a 10BASE-T segment to any of the DLE02-MA and the
DLE52-MA ports, ensure that the network meets the Ethernet network
requirements of the IEEE 802.3 standard for 10BASE-T. Refer to the
Cabletron Systems Cabling Guide for details.
DLE02-MA/DLE52-MA User's Guide
CHAPTER 2
NETWORK REQUIREMENTS
2-1