Table of Contents
Advertisement
HANDLE CONTROL BOX
MAIN WINDOW DISPLAY
The following is displayed on the control box screen.
•
Main window (Differs depending on selected file and display options)
•
Shortcut button
•
Toolbar (Icons of frequently used functions)
•
Pop-up menus of various functions (Differs depending on type of open file and selected information)
ELEVATION CONTROL KEY
"Elevation control key" indicates "Cut/Fill offset" and "Cut/Fill reading" at the blade elevation.
"Elevation control key" also indicates the state of the connected sensor by graphics, information messages, and
colors.
(1) GNSS status
(2) Radio status
(3) Cut/Fill offset (*)
(4) AUTO indicator
(5) Cut/Fill reading
*: "Cut/Fill offset" means the offset quantity of elevation of Sur-
face in the cut/fill direction.
The elevation of Surface can be adjusted finely and temporari-
ly, and it is the same as the value input to "Elevation set point".
•
"Cut/Fill offset" (3) indicates the current cut/fill offsets quantity setting, and you can change it at any time.
When the machine cannot cut to the design elevation, the operator adjusts the cut/fill offsets quantity setting
and changes the design elevation so that the machine can cut/fill.
•
"Cut/Fill reading" (5) indicates the current cut/fill amount.
"Cut/Fill reading" (5) is constantly updated, according to the difference between the blade elevation and cur-
rent Surface elevation (height).
REMARK
The current cut/fill amount means the distance from the current blade elevation to the current design eleva-
tion (design surface height adjusted by the cut/fill offsets quantity setting).
•
The background color of "elevation control key" indicates the state of the sensor.
Green: Displays the optimum state of sensor for grading.
Red: Displays the error state, where automatic control is disabled.
Orange: Displays that GNSS accuracy is low.
•
Icon status
Marks X on "GNSS status" (1) and "radio status" (2) indicates that the corresponding sensors/receivers are
not available.
Flashing of "GNSS status" (1) and "radio status" (2) indicates that the radio connection has been tried for 3
to 10 seconds. (The radio link signal level is low.)
SLOPE CONTROL KEY
(1) Angle of blade
(2) Design cross-slope (*)
(3) Type of control
(4) AUTO indicator
(5) Back grade mode indicator
*: Lateral slope angle of Surface against travel direction of ma-
chine.
MAIN WINDOW DISPLAY
4-69
Hide quick links:
Advertisement
Chapters
Table of Contents
