Komatsu D61EXi-24 Operation & Maintenance Manual page 109

HANDLE CONTROL BOX
3.
On "Project Surfaces" screen, press "New...".
4.
On "Surface Name and Type" screen, press the input sec-
tion for "Name".
5.
Input the name of Surface files to make newly, by using the
alphanumeric keyboard.
6.
Select "Subgrade of Existing Alignment" ("Surface type"),
and press "Next".
7.
On "Subgrade of Existing Alignment" screen, select an
alignment data to refer to create a new alignment data.
8.
Press the input section for "Elevation adjustment :".
9.
Input a value by using the numeric keyboard.
• Positive number
Raises the subgrade from Surface which you are
working on/ referring to.
This is applied to the centerline of Surface which you
are working on/ referring to.
• Negative number
Lowers the subgrade from Surface which you are
working on/ referring to.
This is applied to the centerline of Surface which you
are working on/ referring to.
10. Press the input section for "Grade:".
11. Input a value by using the numeric keyboard.
• "Manual :"
When effective, input the percentage of the right side/ left side of the subgrade element to decide the
slope on the right side/ left side of the machine or road.
• "Copy from :"
When effective, use the grade (slope) of the reference cross section element matched to the input off-
set value (lateral offset amount ( m) from the centerline).
The grade on the right side/ left side is read in from the existing alignment file.
12. Select "Extend slope :".
• When "Vertical" is selected
FILE MENU
AJD02589
AJD02608
AJD02609
4-29