Komatsu D61EXi-24 Operation & Maintenance Manual page 40

MACHINE OPERATIONS AND CONTROLS
13. On "Position Check" screen, select the position of blade
matched with the base point.
• When matched with the left blade edge: "Blade: Left"
• When matched with the right blade edge: "Blade:
Right"
14. Press "Measure...".
The screen shown on the right is displayed.
When the bar at the bottom of the screen reaches the right
end, screen returns to "Position Check" screen.
The elevation recognized by the machine is displayed in
"Elev".
15. Check the elevation recognized by the machine, and press
"Cancel".
The screen returns to the main window.
16. Check that "elevation control key" (1) and "slope control
key" (2) are green and the machine direction on the control
box screen is the same as the actual machine direction.
If the machine direction on the control box screen does not
match with the actual machine direction, repeat the proce-
dure from step 7.
17. Set work equipment lock lever (3) and parking brake lever
(4) to LOCK positions (L).
18. Stop the engine.
At this time, do not turn off the control box power supply.
3-26
OPERATION