VIEW MENU
3.
On "TIN" tab, press "Color", and change "Show triangle
mesh", "Show boundaries/breaklines", or "Show contours
at interval".
You can change the colors of the lines individually. You can
set Display/Non-display of the lines by checking or un-
checking their check boxes.
4.
On "Color Selection" screen, select a color, and press
"Ok".
5.
On "Section" tab, press "Color", and change "Section/
Profile line color :" or "Show grade transitions :".
You can change the colors of the lines or points individual-
ly. You can set display/on-display of the slope-change
point marker displayed in the section view and profile view
by checking or unchecking the check box.
6.
Press "Ok".
METHOD FOR SETTING ALIGNMENT DISPLAY
When using an alignment file, perform the following procedure.
4-62
HANDLE CONTROL BOX
AJD02665
AJD02666
AJD02667