Komatsu D61EXi-24 Operation & Maintenance Manual page 20

EXPLANATION OF COMPONENTS
REMARK
• There is no priority in order between switching on/off of control box power supply and switching on/off of
starting switch of the machine.
• The control box operates on Windows® operating system.
After turning on the control box power supply, it takes approximately 2 minutes until Windows® operating
system starts and the main window is displayed. In the same way, after turning off the control box power
supply, it takes approximately 2 minutes until the main window is finished and Windows® operating system
shuts down.
(Windows is a registered trademark of Microsoft Corporation in the United States and/or other countries.)
AUTO/MANUAL SWITCH
• While the blade automatic control is in operation, the blade moves even if the operator does not op-
erate the blade control lever.
Before turning on the blade automatic control, check thoroughly if there are any persons or obsta-
cles in the area around the machine.
• While the blade automatic control is in operation, if the operator operates blade control lever, this
blade lever operation is given the priority and the blade moves as operated by the operator. When
the operator stops lever operation, the blade automatic control restarts.
While the blade automatic control is in operation, do not release your hand from the blade control
lever, so that you can avoid the danger immediately if any.
• When performing the inspection, maintenance, moving and loading/unloading on the trailer etc., i.e.
other operation than the operation by "intelligent Machine Control" at the jobsite, turn off the blade
automatic control and turn off the control box power supply.
• You can turn off the blade automatic control by setting the work equipment lock lever to LOCK posi-
tion.
Auto/Manual switch is used for turning on or off the blade auto-
matic control.
Auto/Manual switch is located on the blade control lever.
When turning on the blade automatic control
Place the work equipment lock lever in FREE position (F), and
press Auto/Manual switch once.
The blade automatic control is turned on.
3-6
k k
WARNING
OPERATION