Komatsu D61EXi-24 Operation & Maintenance Manual page 61

OPERATION
CUTTING AND CARRY OPERATION
Cutting and carry work is the operation to fill the lower place than the design surface with the soil.
There are 2 methods as follows. Apply these methods depending on the necessity of tamping the filled place.
CARRY SOILS TO HOLE
This is the method when tamping the filled place is not necessary.
Select "Cutting & Carry".
1.
Hold and carry piled soil to a hole by the automatic control of the blade.
2.
When the held soil is all spread out, drive the machine in reverse.
When dropping the held soil from a high place during the cutting and carry operation, leave a pile of the
soil.
(T) Design surface
CARRY AND COMPACT SOILS
This is the method when tamping the filled place is necessary.
This method is not suitable for the operation gradually fill the hollow by piling the soil.
Select "Cutting & Carry".
MACHINE OPERATIONS AND CONTROLS
3-47