Removing And Installing Manual Release Cable For Parking Lock - Audi A4 2015 Workshop Manual

Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
1.8 Removing and installing manual release
cable for parking lock
⇒ "1.8.1 Removing and installing manual release cable for parking
lock - A4/A5", page 29
⇒ "1.8.2 Removing and installing manual release cable for parking
lock (front) - Q5", page 30
⇒ "1.8.3 Removing and installing manual release cable for parking
lock (rear) - Q5", page 32
1.8.1 Removing and installing manual release
cable for parking lock - A4/A5
Removing
WARNING
Accident risk; vehicle can start rolling.
♦ Pull up parking brake button to apply electromechanical
parking brake.
– Remove selector mechanism
– Remove insulation.
– Remove nuts -1, 3- and move mounting -2- for manual release
mechanism clear.
– Release catches -arrows- and lower manual release retainer
-4-.
– Vehicles with 6-cylinder TDI engine: Remove rear noise insu‐
lation ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise
insulation; Removing and installing noise insulation .
– Remove heat shield for tunnel and place down on propshaft
⇒ General body repairs, exterior; Rep. gr. 66 ; Strips / trim
panels / extensions; Exploded view - heat shield .
– Unscrew bolts -arrows-, detach parking lock manual release
cable -1- and move cable clear.
Note
Example shows vehicle with 6-cylinder TDI engine.
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
⇒ page 27 .
29
1. Selector mechanism