Knoll Antenna Telescope Installation Instructions Manual page 86

Telescope 120 Power Strip
Pattern Numbers Represented:
Power Strip, YR1TPS12
Parts List:
Plug Strip (A)
Front Power Strip Clamp (B)
Rear Power Strip Clamp (C)
¼-20 / x / " Hex Socket Flat Head
5 5
32 8
Machine Screw (D)
Knurled Collared Thumb Screw (E)
3/ " Diameter Black Nylon P-Clamp (F)
8
#6 x / Pan Head Wood Screw (G)
5
8
Pre-assembled Telescope 120 Table
Tools Needed:
Power Driver
Phillips #2 Bit
STEPS
1. Join a front power strip clamp (B) and a
rear power strip clamp (C) around the rear
rail of the Telescope table assembly and
fasten together, using a ¼-20
hex socket flat head machine screw (D).
Repeat this assembly with a second
set of the same hardware, and space
the clamp assemblies approximately
8½" apart, centered on the rear rail.
©2021 Knoll Inc.
(A) 3AF5043
(E) 3AF4076
2. Press the back of the plug strip (A) onto
the two clamp assemblies, with the
outlets facing the user side of the table.
/ x / "
5 5
32 8
3. Thread a knurled collared thumb
screw (E) into the bottom of each
clamp assembly and tighten by hand
to fix the plug strip into place.
POWER A ND DATA M A N AGEMENT
(B) 3AF4071 (C) 3AF4072
(F) 3AE5010 (G) 4A22272
4. Use the included
P-clamps with their corresponding #6 x
/ pan head wood screws (I) to manage
5
8
the power cord along the underside
of the worksurface, as necessary.
Antenna Telescope Installation Instructions
86
(D) 3AF4077
/ " dia. black nylon
3
8