Knoll Antenna Telescope Installation Instructions Manual page 83

Power and Cable Management
Telescope Power Strip
Pattern Numbers Represented:
Power Strip, YR1TPS24
Parts List:
Plug Strip (A)
Front Power Strip Clamp (B)
Rear Power Strip Clamp (C)
¼-20 / x / " Hex Socket Flat Head
5 5
32 8
Machine Screw (D)
Knurled Collared Thumb Screw (E)
3/ " Diameter Black Nylon P-Clamp (F)
8
#6 x / Pan Head Wood Screw (G)
5
8
Pre-assembled Telescope Table
Tools Needed:
Power Driver
Phillips #2 Bit
STEPS
1. Join a front power strip clamp (B) and a
rear power strip clamp (C) around the rear
rail of the Telescope table assembly and
fasten together, using a ¼-20
hex socket flat head machine screw (D).
Repeat this assembly with a second
set of the same hardware, and space
the clamp assemblies approximately
19" apart, centered on the rear rail.
©2021 Knoll Inc.
(A) 3AB3520
(E) 3AF4076
2. Press the back of the plug strip (A) onto
the two clamp assemblies, with the
outlets facing the user side of the table.
/ x / "
5 5
32 8
3. Thread a knurled collared thumb screw
(E) into the bottom of each clamp
assembly and tighten by hand to fix
the plug strip into place. Connect the
Upper Mount Management Bracket (B)
to the Upper Mount Top Bracket (A)
using the #8 x 1½" pan head screw (I).
POWER A ND DATA M A N AGEMENT
(B) 3AF4071 (C) 3AF4072
(F) 3AE5010 (G) 4A22272
4. Use the included
P-clamps with their corresponding #6 x
/ pan head wood screws (I) to manage
5
8
the power cord along the underside
of the worksurface, as necessary.
Antenna Telescope Installation Instructions
83
(D) 3AF4077
/ " dia. black nylon
3
8