Knoll Antenna Telescope Installation Instructions Manual page 12

Telescope Dual Table Bases with Beam
(with or without Dual Utility Trays) - Standard Electric
Handset Control
Switch (J)
Steps 18, 19 & 20
INSTALL UTILITY TRAYS (WHERE
APPLICABLE)
16. Insert (2) pairs of 1/4 -20 x 5/8" flanged
button head hex machine screws (X)
loosely into the threaded inserts on the
inner face of the crossbars. Leave a gap
of about 3/16" beneath the head of the
screws. Slip the Utility Tray between the
crossbars and engage the upper screws
into the upper slot on the tray end plate.
Rotate the tray so the lower screws
engage the bottom slot. Tighten the
screws with an Allen wrench.
©2021 Knoll Inc.
Power Supply and Power Cord
iDrive Cable
17. Insert a M6-1 spring nut (Z), centered, into
the slot on the side of the center beam.
Position a Utility Tray Bracket (Y) in front
of the spring nut (Z) and engage the back
edge of the utility tray within the grooves
of the tray bracket. Fasten the tray bracket
to the spring nut with a M6 – 1 x 14mm
flat head machine screw (AA).
Repeat for the other side of the center
beam.
INSTALL THE HEIGHT ADJUSTMENT
ELECTRICAL COMPONENTS
18. For each station, decide if the Handset
Control Switch (J) will be on the left or
right side of the table. Plug the handset
cable into a housing outlet on the chosen
side. Connect one end of the iDrive Cable
into the second outlet on that side.
Note: The latest Power Supply blocks
access to the housing outlets when it is
placed on the Transformer Shelf; use of
a splitter cable is needed. The splitter fits
into the one housing port and provides
two ports out past the Power Supply.
M6 – 1 x 14mm Flat Head
Machine Screw (AA)
Utility Tray Bracket (Y)
M6-1 Spring Nut (Z)
Threaded
Inserts
Step 13
Step 14
Dual Table Base with Beam, Utility
Tray Installation, Steps 16 & 17
Dual Utility Tray
19. Insert splitter into one housing port. Plug
the iDrive cable from the opposite leg into
one splitter port.
20. Insert the power cord into the power
supply and position the power supply on
the Transformer Shelf (F) so that the red
LED is visible from below. Plug the power
supply into the other splitter port.
PERFORM A RESET FOR THE PAIR OF
COLUMNS IN EACH STATION:
21. Plug the power supply into a temporary
power source. Ensure the red LED on the
power supply lights.
22. Apply approximately 100 lbs of weight to
the rails . Press and hold both UP and
DOWN buttons for ten seconds. After
releasing the buttons, press and hold
the DOWN BUTTON until both columns
bottom out. Press the UP button and the
station will be ready to perform normally.
Remove the weight. Run the station all
the way up and down again to ensure
there are no issues with the columns.
Repeat the procedure above for the
opposite pair of columns.
DUAL TABLE BASES
1/4 -20 x 5/8" Flanged
Button Head Hex
Machine Screw (X)
Antenna Telescope Installation Instructions
12