Knoll Antenna Telescope Installation Instructions Manual page 45

Telescope 120˚ Triad with Beam
(with or without Dual Utility Trays)
/
5
16
Hex Machine Screw (L)
Step 1
Right Hand Column
Leg Assembly (A)
Exploded 120 Triad Table Outer
Leg Assembly, Steps 1-3
Steps:
NOTE: Before assembly, determine if the
120° triad has 1, 2, 3, or no end connections
(and where those connections are located.)
PREPARE OUTER LEGS & CROSSBARS:
1. Attach (2) Horizontal Rail Cradles (C) to
the upper housing boxes on the Right
Hand and Left Hand Column Assemblies
(A/B), with (2) / -18 x 1-¼" button head
5
16
hex machine screws (L) per cradle.
©2021 Knoll Inc.
-18 x 1 ¼" Button Head
Horizontal Rail
Cradle (C)
Step 2
¼-20 x
Head Phillips
Machine
Screw (M)
2. Attach a Housing Cover (E) to the
short end of each housing, using
(2) ¼-20 x
machine screws (M) per cover.
3. Attach a Transformer Shelf (F) to the
opposite side of each housing, using
(2) ¼-20 x
screws (M) per shelf.
Repeat steps 1-3 for all three
pairs of outer legs
Housing
Cover (E)
" Flat
/
5
8
/ " flat head Phillips
5
8
/ " flat head Phillips machine
5
8
120 º TRIAD BASES
Step 3
Transformer Shelf (F)
¼-20 x
Head Phillips
Machine Screw (M)
Left Hand Column
Leg Assembly (B)
NOTE: Do not attempt to rotate the outer
column tube unless the column is moving
either upward or downward. If it is necessary
to orient the welded column bracket, you
must first, temporarily connect a power
supply and handset. Then plug the power
supply to building power. Depress the Up
button to run the column upward, ONLY
while the column is running, rotate the
outer column tube to orient the bracket
as shown in the above image. Lower the
column and disconnect the power supply
from the building power, then from the leg.
Antenna Telescope Installation Instructions
45
" Flat
/
5
8