Knoll Antenna Telescope Installation Instructions Manual page 37

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Side by Side Application
Pattern Numbers Represented:
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam Only, Left Hand, YBTSSFESBNL_
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam Only, Right Hand, YBTSSFESBNR_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam Only, Left Hand, YBTSSFEXBNL_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam Only, Right Hand, YBTSSFEXBNR_
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam and Tray, Left Hand, YBTSSFESBTL_
Telescope Single Sided Base, Height Adjustable Standard
Electric, with Beam and Tray, Right Hand, YBTSSFESBTR_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam and Tray, Left Hand, YBTSSFEXBTL_
Telescope Single Sided Base, Height Adjustable Extended
Electric, with Beam and Tray, Right Hand, YBTSSFEXBTR_
Supplemental Parts List:
[See the installation instructions for Telescope Single Sided
Table Bases with Beam (with or without Utility Tray), Stand-
Alone Application for a complete list of additional parts.]
¼-20 x .75" Button Head Machine Screw (A)
¼-20 x ¾" Flat Head Phillips Machine Screw (B)
Dovetail Linking Brackets (C)
Wire Hanger (D)
Connector Link (E)
Tools Needed:
Power Drive
Phillips #2 and #3 Bits
/ ", 3/ ", ¼" Hex Bit Sockets
5
32 16
Ratchet Torque Wrench (150 in-lb) for 3/
4mm Allen Wrench
Level (or Laser Level)
Rubber Mallet
Steps:
NOTE: These directions are to be used in
conjunction with the installation instructions
for Telescope Single Sided Table Bases
with Beam (with or without Utility Tray),
Stand-Alone Application. The instructions
below only address the modifications
necessary to connect single sided
tables for a side by side application.
PREPARE TABLES FOR CONNECTION:
Please refer to instructions for Telescope
Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone
Application, and complete the following
steps for each table to be connected.
©2021 Knoll Inc.
(A) 7283140
(D) 3AF4090*
" Hex Bit Socket
16
Follow steps 1-5 to prepare
legs and crossbars.
*NOTE VARIABLES FOR STEP 4:
There will be different drilling patterns on
the crossbars. Single Sided Crossbars
in an "end" location will have holes on
the inner side to accept the legs at front
and beam at back (and utility trays in
center, where specified). Single Sided
Crossbars in a "connected" location will
have additional drillings on the outer
side to accept Connector Links.
SINGLE SIDED TABLE BASES
(C) 3AF4009*
(B) 7418440
(E) 3AF4010*
Follow steps 6-8 to connect beam
to crossbars. Follow steps 9-10 to
connect crossbars to legs.
Follow steps 11-14 to prepare
& install back panel.
Follow steps 15-18 to install rails.
Follow steps 19-20 to install
utility trays (where applicable).
Follow steps 21-23 to level tables.
Follow steps 24-26 to install the height
adjustment electrical components.
Follow steps 27-28 to perform a reset
for the pair of columns in each station.
Antenna Telescope Installation Instructions
37