Knoll Antenna Telescope Installation Instructions Manual page 11

Telescope Dual Table Bases with Beam
(with or without Dual Utility Trays) - Standard Electric
Rail End Cap (T)
1/4-20 x 5/8"
Flat Head Phillips
Machine Screw (M)
Cradle Clamp
Bracket (D)
Horizontal
Rail Cradle (C)
11. Install (8) Rail End Caps (T) onto the ends
of the rails using a rubber mallet.
12. Prepare the leg cradles for the rails by
fastening (2) Cradle Clamp Brackets (D)
loosely to each cradle (C) using (4) ¼-20 x
5/8" flat head Phillips machine screws (M)
per cradle.
©2021 Knoll Inc.
Rails
Note: The cradle clamp brackets (D) are
ALWAYS to be placed in the outer position
in the cradle (C), and the end is to be flush
with the face of the housing cover (E).
13. Slide the ends of (4) rails into the cradles
on a crossbar assembly. Position the rails
so that the end cap (T) sticks out past the
cradle by ¼".
Dual Table Base with Beam, Rail
Installation, Steps 11 ,12, 13, 14 & 15
Note: The original Antenna install gauge is
to be used to set Telescope rail positions.
14. Tighten the screws (M) in the cradle clamp
brackets (D).
15. Slide the free ends of the rails into the
opposite crossbar assembly and repeat
the above tightening procedure.
Antenna Telescope Installation Instructions
DUAL TABLE BASES 11
Note: Cradle
Clamp Brackets
(D) in Outer
Position