Knoll Antenna Telescope Installation Instructions Manual page 58

Telescope Return Bases
Steps 5, 8 & 9
Rall End Cap (J)
Longer Rail
(User Front)
PREPARE THE RAILS
5. Install (1) Rail End Cap (J) into the end
of each return rail using a rubber mallet.
6. In the longer of the two return
rails, install a Return Rail Hook Top
Bracket (G) in the uncapped end.
7. In the shorter of the two return rails,
install an End Cap with Support Tab (I).
©2021 Knoll Inc.
Shorter Rail
Longer Rail
(User Front)
ADD RAILS TO THE RETURN COLUMN
8. Slide (2) rails into the cradles on the
return
column. Position them so that
the longer rail is forward (toward
the user), and the shorter rail
is rearward on the return.
Position the rails so that the end cap
(J) sticks out past the cradle by ¼".
RE TUR N BASES
Step 7
End Cap with
Step 6
Support Tab (I)
Return Rail Hook Top
Bracket (G)
Note: The original Antenna install
gauge is not to be used to set
Telescope rail positions.
9. Tighten the screws (N) in the
cradle clamp brackets (C).
Antenna Telescope Installation Instructions
58