Knoll Antenna Telescope Installation Instructions Manual page 102

Telescope Dual Utility Tray Covers
Pattern Numbers Represented:
Dual Utility Tray Covers, YR1TTC_ _
Dual Utility Tray Covers, YR1TTCA_ _
Parts List:
Cover Support Bracket (A)
Clamping Bracket (B)
Flip Door Stop (C)
M6-1 Spring Nut (D)
M6-1 x 14mm Flat Head Machine Screw (E)
8-32 x .625 Flat Head Machine Screw (F)
Tray Covers (Widths Vary Per Application)
Pre-assembled Telescope Table
with Dual Utility Tray
Tools Needed:
Manual Ratcheting Phillips Head Screwdriver
Power Driver
Phillip #2 Bit
STEPS
1. Build a single cover support bracket
assembly by loosely attaching a clamping
bracket (B) to the back of a cover support
bracket (A) with an 8-32 x .625 flat head
machine screw. Do not tighten screw.
Keep the clamping bracket (B) oriented
perpendicular to the support bracket (A).
Repeat for (3) more cover support
bracket assemblies. There will
be 4 total per utility tray.
2. Insert the support bracket assemblies into
the utility tray. They should be positioned
so that they will support the tray covers,
approximately 3 inches from the edges of
the covers.
©2021 Knoll Inc.
(A) 3AF5035
(D) 3AB4021
NOTE: The outside edges of the two
covers will align with the sides of the data
tray, leaving a gap between the covers
for the placement of a Z-manager. l.
3. For each assembly positioned, rotate
the clamping bracket (B) so it is vertical
and fits behind the lip of the utility tray.
4. Tighten the 8-32 x .625 flat head machine
screws (F) until the support bracket
assemblies are secure in the utility tray.
POWER A ND DATA M A N AGEMENT
(B) 3AF5009 (C) 3AB4058
(E) 3AB4056 (F) 4A22237
5. Opposite each support bracket assembly,
insert a M6-1 spring nut (D) into the
slot on the side of the center beam.
6. Position a flip door stop (C) in front of each
spring nut (D), fastening each with a M6
– 1 x 14mm flat head machine screw (E).
7. Position the utility tray covers on top of
the support bracket assemblies and door
stops, ensuring that the outside edges
of the two covers align with the sides of
the utility tray, leaving a gap between the
covers for the placement of a Z-manager.
Antenna Telescope Installation Instructions
102