Knoll Antenna Telescope Installation Instructions Manual page 76

SCREENS
Telescope Fixed Center Screen, Fabric
Pattern Numbers Represented:
Fixed Center Screen, Fabric, YPSCF_ _
Parts List:
Bayonet Mount Bracket (A)
Spring Nut (B)
M6-1 x 25mm Flat Head PHDR
Machine Screw (C)
Screen
Pre-assembled Telescope Table
Tools Needed:
Phillip #3 Screwdriver
STEPS
1. Insert (4) spring nuts (B) into the
top slot in the center beam (i.e. (2)
per bayonet mount bracket).
2. Attach (2) bayonet mount brackets (A)
loosely to the spring nuts (B), using (2)
M6-1 x 25mm PHDR machine screws
(C) per bracket. Do not tighten.
3. Determine the desired screen position
along the width of the table, and adjust/
slide the location of the bayonet mount
©2021 Knoll Inc.
(A) 3AB4082
brackets (A) along the center beam so
they will correspond with the openings
on the underside of the screen.
4. Tighten the screws (C) in the bayonet
mount brackets (A) to secure their
locations.
Position the openings in the underside
of the screen over the bayonet mount
brackets (A) and push the screen down
until the screen is firmly seated.
(B) 3AB4021 (C) 3AB405540
Antenna Telescope Installation Instructions
SCREENS 76