Knoll Antenna Telescope Installation Instructions Manual page 34

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
Rail End Caps (S)
¼-20 x / " Flat Head Phillips
5
8
Machine Screw (L)
Cradle Clamp Brackets (E)
Horizontal Rail Cradle (D)
INSTALL RAILS:
15. Install (4) Rail End Caps (S) onto the
ends of the rails using a rubber mallet.
16. Prepare the leg cradles for the rails by
fastening (2) Cradle Clamp Brackets
(E) loosely to each cradle (D) using
(4) ¼-20 x / " flat head Phillips
5
8
machine screws (L) per cradle.
NOTE: The cradle clamp brackets (E) are
ALWAYS to be placed in the outer position
in the cradle (D), and the end is to be flush
with the face of the housing cover (F)
©2021 Knoll Inc.
Rails
Exploded Single Sided Table Base Assembly,
Steps 15-18: Rail Installation
17. Slide the ends of (2) rails into the
cradles on a crossbar assembly.
Position the rails so that the end cap
(S) sticks out past the cradle by ¼".
NOTE: The original Antenna install gauge is
not to be used to set Telescope rail positions.
SINGLE SIDED TABLE BASES
Note: Cradle Clamp Brackets (E)
in Outer Position
18. Tighten the screws (L) in the cradle
clamp brackets (E). Slide the free
ends of the rails into the opposite
crossbar assembly and repeat the
above tightening procedure.
Antenna Telescope Installation Instructions
34