Knoll Antenna Telescope Installation Instructions Manual page 90

Telescope Z-Managers
CREATE THE "S" or "Z":
NOTE: The upper flex strap of the
subassembly (F) is always convex toward
the cord management channel, i.e., the
cords will be outside the bend when the
corrugated strap is curved. The lower flex
strap of the subassembly (F) is always
concave toward the cord management
channel, i.e., the cords will lie inside
the bend when the strap is curved.
9. With the subassembly (F) facing forward
and straightened out, flex it so that the
upper flex strap bends away from the
cord channel, and the bottom flex strap
bends toward the cord channel.
This results in either the "S" orientation or
the "Z". If it is not the desired orientation,
straighten the subassembly (F) back up,
and rotate the subassembly 180° so that
the top becomes the bottom (keeping
the opening side facing forward.) Then
flex the straps again so that the upper
flex strap bends away from the cord
channel and the bottom flex strap bends
toward the cord channel. This will result
in the desired orientation, "S" or "Z".
10. Having identified the upper end of
the subassembly (F), insert the Upper
Corrugated Strap (G) into the upper
extrusion of the subassembly so that
the buttons snap into the holes.
11. Similarly, insert the Lower Corrugated
Strap (H) into the lower extrusion
of the subassembly (F).
12. Snap the upper portion of the now
lengthened strap assembly into the
Upper Mount Management Bracket (B),
previously mounted to the underside of
the top. Be sure the desired orientation
is maintained and that the cord channel
of the strap assembly is in line with
the cord channel of the mount.
13. Similarly, insert the lower portion of the
strap assembly into the beam mounted
Lower Mount Bracket (C). Be sure that the
cord channel of the strap assembly is in
line with the cord channel of the mount.
14. Lower the table to the desired
end-user height.
©2021 Knoll Inc.
TROUBLESHOOTING THE
CORD CHANNEL:
15. If you find that the cord channel is
difficult to open, a flat-blade screwdriver
may be used to pry apart the snapped
connection at one end, then "unzip"
the seam all the way to the other end.
Z-Managers, Plan View,
Back to Back Configuration.
POWER A ND DATA M A N AGEMENT
Z-Managers
Beam
Antenna Telescope Installation Instructions
90