Knoll Antenna Telescope Installation Instructions Manual page 35

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
Step 20
INSTALL UTILITY TRAYS
(WHERE APPLICABLE):
19. Insert (2) pairs of ¼ -20 x
button head hex machine screws (W)
loosely into the threaded inserts on the
inner face of the crossbars. Leave a
gap of about 3/ " beneath the head of
16
the screws. Slip the Utility Tray between
the crossbars and engage the upper
screws into the upper slot on the tray
end plate. Rotate the tray so the lower
screws engage the bottom slot. Tighten
the screws with an Allen wrench.
20. Insert a M6-1 spring nut (Y) into the slot
on the front face of the center beam.
Position a Utility Tray Bracket (X) in front
of the spring nut (Y) and engage the back
edge of the utility tray within the grooves
of the tray bracket. Fasten the tray
bracket to the spring nut with a M6 - 1
x 14mm flat head machine screw (Z).
©2021 Knoll Inc.
M6-1 Spring Nut (Y) Utility Tray Bracket (X)
LEVEL TABLE:
21. Place the table in its final position
/ " flanged and level by extending the
5
8
leveling glides as needed.
22. Pay close attention to column orientation.
Ensure both columns are truly vertical
and, in-particular, parallel to each other.
23. When levelers are extended more
than ½", it may be desirable to install
the Helical Glide Shroud. See Helical
Glide Installation Instructions.
INSTALL THE HEIGHT ADJUSTMENT
ELECTRICAL COMPONENTS:
24. For each station, decide if the Handset
Control Switch (J) will be on the left or
right side of the table. Plug the handset
cable into a housing outlet on the chosen
side. Connect one end of the iDrive Cable
into the second outlet on that side.
Note: The latest Power Supply blocks
access to the housing outlets when it is
placed on the Transformer Shelf; use of
a splitter cable is needed. The splitter fits
into the one housing port and provides
two ports out past the Power Supply.
Utility Tray
Exploded Single Sided Table Base Assembly,
Steps 19-20: Utility Tray Installation
SINGLE SIDED TABLE BASES
Step 19
Threaded Inserts
¼-20 x 5/8" Flanged
Button Head Hex Machine
Screw (W)
M6-1 x 14mm Flat Head
Machine Screw (Z)
25. Insert splitter into one housing
port. Plug the iDrive cable from the
opposite leg into one splitter port.
26. Insert the power cord into the power
supply and position the power supply
on the Transformer Shelf (F) so that the
red LED is visible from below. Plug the
power supply into the other splitter port.
PERFORM A RESET FOR THE PAIR
OF COLUMNS IN EACH STATION:
27. Plug the power supply into a temporary
power source. Ensure the red LED
on the power supply lights.
28. Apply approximately 100 lbs of weight
to the rails. Press and hold both UP and
DOWN buttons for ten seconds. After
releasing the buttons, press and hold
the DOWN BUTTON until both columns
bottom out. Press the UP button and the
station will be ready to perform normally.
Remove the weight. Run the station all
the way up and down again to ensure
there are no issues with the columns.
Antenna Telescope Installation Instructions
35