Knoll Antenna Telescope Installation Instructions Manual page 93

Power and Cable Management
Telescope Hinged Cleat Plate Covers
Pattern Numbers Represented:
Hinged Cleat Plate Cover, YR1TCPC_
Parts List:
Rail Clip (A)
#6 x / " Wood Screw (B)
5
8
Cleat Plate Cover
Pre-assembled Telescope Table with
Cleat Plate and Power Strip
Tools Needed:
Pry Bar
Phillips Screw Driver
STEPS
1. Determine the side-to-side location for
the hinged plate cover. The cover should
be mounted directly below the cleat
plate cable manager and power strip.
2. Attach two rail clips (A) to the back
desk rail, from behind the rail, one
on either side of the power strip.
NOTE: If the worksurface has already
been attached, a pry bar may need
to be used to create a gap large
enough to position the clips between
the worksurface and the rail.
©2021 Knoll Inc.
(A) 3AF4137
3. Adjust the spacing of the rail clips
as necessary, and hang the cleat
plate cover from the hooks at the
bottom of the rail clips (A).
4. Rotate the cleat plate cover up so that
it engages with both rails. The back
edges should engage the back rail
first, followed by the front edge of the
cover, which will engage the front rail.
POWER A ND DATA M A N AGEMENT
(B) 7528496
NOTE: The cleat plate cover's back tabs
may need to be bent and adjusted for
proper fit and secure connection to rails.
5. Screw a #6 x 5/8" wood screw (B) into
each rail clip (A) to secure their placement.
Antenna Telescope Installation Instructions
93