Knoll Antenna Telescope Installation Instructions Manual page 36

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
Step 31
Handset Control Switch (I)
#6 x 5/8" wood screws (J)
INSTALL TOPS:
29. Lay tops on base assembly. Place a
Spacer (P) between the top of each rail
and the underside of the top, centered
on the width of the top. Spacers are
attached to the top using (1) #12 X ¾" flat
head black wood screw (Q) per spacer.
NOTE: Tops are predrilled so that the
front edge is 12" from the center of the
column leg, for all worksurface depths.
30. Attach tops using (4) #14 x 1" flat
head wood screws (R) per cradle.
©2021 Knoll Inc.
Exploded Single Sided Table Base Assembly,
Steps 29-31: Top & Handset Installation
NOTE: Several screw hole locations
are directly above the crossbars, so
it is convenient to raise the station to
make room for the power driver.
AFFIX HANDSET:
Note: If a return is to be attached,
skip this step and follow Telescope
Return Base Installation Instructions.
31. Using (2) #6 x / " wood screws
5
8
(J) mount the Handset Control
Switch (I) to the underside of the
worktop, at the front edge.
SINGLE SIDED TABLE BASES
Worksurface Top
Step 29
Spacer (P)
#12 x ¾" Flat Head Black
Wood Screw (Q)
Step 30
#14 x 1" Flat Head
Wood Screw (R)
ATTACH RETURNS (WHERE
APPLICABLE):
See Telescope Return Base
Installation Instructions.
INSTALL POWER STRIP ACCESSORY
(WHERE APPLICABLE):
See Power Strip Installation Instructions.
INSTALL CLEAT PLATE & CLEAT
PLATE COVER ACCESSORIES
(WHERE APPLICABLE):
See Cleat Plate and Cleat Plate
Cover Installation Instructions.
Antenna Telescope Installation Instructions
36