Knoll Antenna Telescope Installation Instructions Manual page 62

Telescope Y-Base Adjustable Height Tables
INSTALL THE HEIGHT ADJUSTMENT
ELECTRICAL COMPONENTS
9. Determine if the Handset Control
will be centered, or on the left
or right side of the table.
Note: The latest Power Supply blocks
access to the housing outlets when it is
placed on the Transformer Shelf; use of
a splitter cable is needed. The splitter fits
into the one housing port and provides
two ports out past the Power Supply.
10. Plug the handset cable into a housing
outlet on the chosen side. Connect one
end of the iDrive Cable into the second
outlet on that side. At the other leg, Insert
splitter into one housing port. Plug the
iDrive cable from the other leg into one
splitter port.
©2021 Knoll Inc.
11. Insert the power cord into the power
supply and position the power supply on
the Transformer Shelf (F) so that the red
LED is visible from below. Plug the power
supply into the other splitter port
INSTALL TOPS:
12. Lay tops on base assembly and attach
tops using (4) #14 x 1" flat head wood
screws (M) per Top Support Bracket (E/F).
LEVEL TABLES:
13. Place the tables in their final positions
and level by extending the leveling glide
assemblies (A) as needed.
Y-Base Adjustable Height Table, Assembled
Y- BASE AD JUSTABLE- HEIGHT BASES
PERFORM A RESET FOR THE
COLUMNS:
14. Plug the power supply into a power
source. Ensure the red LED on the power
supply lights.
15. Apply approximately 100lbs of weight to
the table. Press and hold both UP and
DOWN buttons for ten seconds. After
releasing the buttons, press and hold
the DOWN BUTTON until both columns
bottom out. Press the UP button and the
table will be ready to perform normally.
Remove the weight. Run the table all the
way up and down again to ensure there
are no issues with the columns.
Antenna Telescope Installation Instructions
62