Knoll Antenna Telescope Installation Instructions Manual page 74

Telescope End Panels for Single Sided Table
Continue as follows:
POSITION CONNECTOR LINKS:
1. Attach (2) Dovetail Linking Brackets
(B) to the outside of the crossbar at
the "end panel" location using (2) ¼
-20 x .75" flat head machine screws
(G) for each bracket. The base of the
"L" should be oriented downward.
2. Slide the (2) End Panel Connector
Links (A) down onto the linking
brackets attached to the crossbar.
Do not fasten from below yet.
©2021 Knoll Inc.
Step 11
¼-20 x .75" Flat Head
Machine Screw (G)
Single Sided Base Assembly, Partially Exploded, Crossbar
and Back PAnel Preparation, Steps 1-2, 9 & 11
* Additional for Step 14
PREPARE END PANEL:
3. Attach (3) Keyhole Plates (J) to the end
panel with (2) #5 x ¾ flat head wood
screws (K) per plate. Be sure to orient
the keyhole plate so that the screw
head opening is towards the bottom,
and the slot is towards the top.
4. Attach (2) Dovetail Linking Brackets
(B) to the holes with threaded inserts
holes in the center of the end panel,
using (2) ¼ -20 x .75" Flat Head
Machine Screws (G) per bracket.
END PA NELS
*Note addition for Step 14:
10-24 x .35 Bushing (M)
#10-24 x 3/ Zinc Flat HEad
8
Shoulder Screw (L)
Steps 2 & 9
End Panel Connector Links (A)
Step 1
¼-20 x .75" Flat Head Machine
Screw (G)
Dovetail Linking Bracket (B)
5. Attach the End Panel Block (C) to the
holes with threaded inserts holes on the
bottom of the end panel, using (2) ¼-20
x 1.25" Flat Head Machine Screws (H).
6. Apply a strip of Polyurethane Grip
Tape (F) to the inside curved surface
of the End Panel Leg Brace (D/E).
Antenna Telescope Installation Instructions
74