Knoll Antenna Telescope Installation Instructions Manual page 33

Telescope Single Sided Table Bases with Beam
(with or without Utility Tray), Stand-Alone Application
Step 11
Single Sided Back
Panel Crossbar
Bracket, LH (AA)
11. Attach a Single Sided Back Panel
Crossbar Bracket, LH (AA) to the
pre-drilled holes in the left side of the
back panel with (2) 5 / -18 x .75" button
16
head hex machine screws (DD). Repeat
on the right side with a Single Sided
Back Panel Crossbar Bracket, RH
(BB). Ensure that the gusset webs are
facing outward for both brackets.
©2021 Knoll Inc.
/ -18 x .75" Button Head
5
16
Hex Machine Screw (DD)
Step 12
¼-20 x ¾" Flat Head Phillips
Machine Screws (CC)
Exploded Single Sided Table Base Assembly,
Steps 11-14: Back Panel Installation, Show from Below
12. Stand the back panel up and hold
it in place. Have a second installer
position the base assembly so that
the back panel crossbar brackets (AA/
BB) enter the back of the crossbars.
Ensure the bottom flange of both
brackets is BELOW the Rivnuts inside
the crossbars. Attach the brackets to
the crossbars, using (2) ¼-20 x ¾" flat
head Philips machine screws (CC) per
bracket, from below the crossbars.
SINGLE SIDED TABLE BASES
Back Panel
13. Insert (2) M6-1 spring nuts (Y) into the
underside of the beam, and attach
a Single Sided Centerbeam Bracket
(EE) to each, loosely, with a M6-10mm
button head hex machine screw (FF).
14. Align the (2) Single Sided Centerbeam
Brackets with the predrilled holes
in the back panel, and attach the
brackets to the panel, with (2)
.75" button head hex machine screws
(DD) each. Tighten the (2) M6-10mm
button head hex machine screws
(FF) in underside of the beam.
Antenna Telescope Installation Instructions
33
Step 13 & 14
M6-1 Spring Nut (Y)
/ -18 x .75" Button Head
5
16
Hex Machine Screw (DD)
M6-10mm Button Head
Hex Machine Screw (DD)
Single Sided Centerbeam
Bracket (EE)
/ -18 x
5
16