Knoll Antenna Telescope Installation Instructions Manual page 24

Telescope Dual Table Bases with Mixed or
Fixed Base
Pattern Numbers Represented:
Telescope Base, Fixed Height, YBTFS_ _ _ _ _
Telescope Base, Mixed Standard Electric
and Fixed Height, YBTFES_ _ _ _ _
Parts List:
Right Hand Fixed Column Leg Assembly
Left Hand Fixed Column Leg Assembly
Ballast Kit
Additional Parts:
See Parts List from Telescope Dual Table Bases
with Beam (with or without Dual Utility Trays)
Tools Needed:
See Parts List from Telescope Dual Table Bases
with Beam (with or without Dual Utility Trays)
STEPS
NOTE: The following instructions are to
be used in conjunction with the installation
instructions for Telescope Dual Table
Bases with Beam (with or without Dual
Utility Trays). The instructions below only
address the slight modification required for
the preparation of the fixed leg assembly.
TO PREPARE FIXED LEGS:
1. Drop one ballast kit into both the
Right Hand and Left Hand Column
Leg Assemblies. DO NOT REMOVE
THE BALLAST FROM THE BAG.
©2021 Knoll Inc.
(A) 3AF4093R*
TO CONTINUE INSTALLATION:
Please refer to instructions for Telescope
Dual Table Bases with Beam (with
or without Dual Utility Trays).
Follow steps 1-5 to prepare legs & crossbars.
Follow steps 6-8 to connect
beam to crossbars.
Follow steps 9-10 to connect
crossbars to legs.
Follow steps 11-12 to install rails.
A NTENN A
(B) 3AF4094L*
Follow steps 13-14 to install utility
trays (where applicable).
Follow steps 20-22 to attach connector
links/connect tables (where applicable).
Follow steps 23-24 to level tables.
Follow steps 25-26 to install tops.
Antenna Telescope Installation Instructions
TELESCOPE 24
® ™