Knoll Antenna Telescope Installation Instructions Manual page 13

Telescope Dual Table Bases with Beam
(with or without Dual Utility Trays) - Standard Electric
Worksurface Tops
Handset
Control
Switch (J)
#6 x 5/8"
Wood
Screws (K)
#14 x 1" Flat
Head Wood
Screws (S)
ATTACH CONNECTOR LINKS/ CONNECT
TABLES (WHERE APPLICABLE)
23. Attach (2) Dovetail Linking Brackets (BB)
to the outside of the crossbar using (2) 1/4
-20 x 3/4" flat head machine screws (CC).
The base of the "L" should be oriented
downward.
24. Prepare the Connector Link (EE) for the
Wire Hanger (DD) by loosely screwing (2)
1/4-20 x 3/4" button head machine screws
(V) into the underside of the connector
link. Leave a gap of about 3/16" beneath
the head of the screws. Place the wire
hanger over the heads of the screws and
slide to engage the keyhole slots.
©2021 Knoll Inc.
Spacer (Q)
#12 X 3/4" Flat Head
Black Wood Screw (R)
25. To connect tables, position both table
assemblies side by side so the prepared
connector links (EE) can be slid down
onto the linking brackets (BB) previously
attached to the crossbars. Fasten the
connector links to the linking brackets with
a 1/4 -20 x 3/4" flat head machine screw
(CC).
LEVEL TABLES
26. Place the tables in their final positions and
level by extending the leveling glides as
needed.
27. When levelers are extended more than
1/2", install the Helical Glide Shroud. See
Helical Glide Installation Instructions.
Mid Crossbar (H)
Dovetail
Linking
Bracket
(BB)
Connector
Link (EE)
Wire Hanger
(DD)
Attaching Connector Links
Detail, Steps 23-25
Exploded Table Base with Beam
Assembly, Steps 23-30
INSTALL TOPS
28. Lay tops on base assembly. Place a
Spacer (Q) between the top of each rail
and the underside of the top, centered on
the width of the top. Spacers are attached
to the top using (1) #12 X 3/4" flat head
black wood screw (R) per spacer.
Note: Back to back tops are to be 6"
apart.
29. Attach tops using (4) #14 x 1" flat head
wood screws (S) per cradle.
Note: Several screw hole locations are
directly above the crossbars, so it is
convenient to raise the station to make
room for the power driver.
Antenna Telescope Installation Instructions
DUAL TABLE BASES 13
1/4 - 20 x 3/4"
Flat Head
Machine
Screws (CC)
1/4-20 x 3/4"
Button Head
Machine
Screws (V)