Hub Configuration Menu - HP 10Base-T Hub 24M Manual

Configuration Reference
Attribute
Screen Name
Menu
Function
Common Use
Browser Interface Window
Browser Interface Tab
The Hub Configuration Menu displays a list of menus and options that enable
you to perform hub and port configuration tasks. The menus and options are
listed here.
6-56

Hub Configuration Menu

Description
Hub Configuration Menu
--
Displays a list of options that enable you to perform hub and
port configuration tasks.
Launches options that enable you to perform hub and port
configuration tasks.
--
Configuration
Hub System Information. Displays hub identification information and
system attributes.
Port Enable/Disable. Enables you to turn ports on and off, allowing
them to receive and transmit packets.
Port Security. Displays security information about all ports on the hub,
showing the address learning method, authorized manager address for the
hub, whether Eavesdrop Prevention has been enabled, and whether an
alarm is to be sent in the event of an unauthorized packet. The console
allows Port Security to be disabled.
Backup Links. Enables you to configure a primary and a redundant
communication link between multiple hubs in a cascaded topology, using
two separate cables and two ports on each hub. One port is defined as the
primary port and the other the backup port. The backup port becomes
active only if the primary port becomes inactive, and will automatically
deactivate if the primary port becomes active again. Any of the network
ports (twisted-pair or AUI/Xcvr) can be used as either the primary or
backup port.
Reset Hub to Factory Defaults. Enables you to reinitialize the hub's
counters in the event that the device is performing incorrectly. All devices
are shipped with various counters, byte addresses and other variables set
to specific values. By resetting these parameters, you can correct the
performance of a failing device.