Configuration - HP 10Base-T Hub 24M Manual

Configuration

Figure 4-11. The Configuration Tab Bar
This tab displays the Configuration Button bar which contains buttons that
launch sessions enabling you to set or change values in various configuration
areas on your hub. The buttons are:
Device View. Displays a graphical representation of the front panel of the
device, allowing you enable and disable ports on the device by clicking
on port graphics and an enable or disable port button.
Fault Detection. Controls the alert log sensitivity, and port disabling.
System Information. Enables you to view and set system information
for a selected device.
IP Configuration. Enables you to change existing value for an IP
address, subnet mask, and the gateway address for the hub.
Port Configuration. Enables you to enable and disable ports in addition
to viewing the security and source address information.
Backup Links. Enables you to configure a primary and a redundant
communication link between two hubs in a cascaded topology, using two
separate cables and two ports on each hub.
Support URL. Specifies the URL of the web site that will be automatically
accessed when you open the Support tab. If you have an internal support
structure, you may wish to change this.
Running the Browser Interface
4-17