Setting Security On Ports In The Browser Interface - HP 10Base-T Hub 24M Manual

Configuration Reference
Figure 6-30. The Port Security Window

Setting Security on Ports in the Browser Interface

To set security parameters on a port on the hub, perform the following steps:
1.
2.
3.
6-74
From the Tab Bar, click on the Security Tab. The Browser Interface
displays the Security Button Bar.
From the Security Button Bar, click on the Port Security Button. The
Browser Interface displays the Port Security Window. Note the window
contains a Port List with columns of security information corresponding
to it.
Launch the Port Security Configuration Window. You can do this in one
of two ways:
• Double click on the port.
• Click on a port to highlight it (the port number and all corresponding
fields of information are darkened). Then click on the Set Security
Policy for Selected Ports Button.
The Browser Interface displays the Port Configuration Window. Take a
moment to review this window. It contains several fields and list boxes
that enable you to set security parameters. Also, note the current port
selected is displayed at the top of the Window.
Port 5 will disable itself
because it does not
recognize the MAC
address of a packet sent
to it (080009-123458).