HP 10Base-T Hub 24M Manual page 100

3. Type in the IP Address of the device that you want to act as a manager for
the hub and press [Enter]. The Hub Console Interface displays the
following prompt:
Enter in manager IP mask:
4. Type the security mask for the device that you want to act as a manager
for the hub and press [Enter]. HP recommends you use a security
mask value of 255.255.255.255.
The Hub Console Interface displays the authorized manager list with the
authorized manager you just created at the bottom of the list. Note that
the authorized manager is identified first by its community name (far left
column) and then by network addressing information associated with the
management station.
To Remove an Authorized Manager, perform the following steps:
Type D and press [Enter]. The Hub Console Interface displays the
1.
following prompt:
Select manager to delete (1-#):
2. Type the number of the authorized manager that you want to remove from
the Authorized Managers List and press [Enter].
The Hub Console Interface displays the authorized manager list. Note that
the authorized manager you just removed no longer is displayed in the
Authorized Manager List.
To Edit an Authorized Manager, perform the following tasks:
Type E and press [Enter]. The Hub Console Interface displays the
1.
following prompt:
Select manager to edit (1-#):
2. Type the number of the authorized manager that you want to edit and
press [Enter]. The Hub Console Interface displays a numbered list
of all available Community Names and the following prompt:
Select community for manager (1-#):
3. Type the number of the Community Name you want to assign the autho-
rized manager and press [Enter]. The Hub Console Interface
displays the following prompt:
Enter in Manager IP Address
Configuration Reference
6-43