HP 10Base-T Hub 24M Manual page 143

Configuration Reference
Figure 6-38. Editing a Backup Link
To edit or delete a Backup Link
1.
2.
3.
4.
5.
6.
7.
6-86
Type E to edit a backup link or D to delete a backup link and press
[Enter]. The Hub Console Interface displays the following prompt:
Select backup link to delete or edit (1-#):
Type the number of the backup link that you want to modify and press [Enter].
Enter in primary port in backup link configuration (1-
24, XCVR):
Type the number of the port on the local hub for which you want to
reassign a backup port or delete a backup link assignment. Press
[Enter]. The Hub Console Interface displays the following prompt:
Enter in backup port on Backup Link Configuration (1-24):
Type the number of the port that will act as the backup port when the
primary port fails. Press [Enter]. The Hub Console Interface displays the
following prompt:
MAC Address of test destination.
Type the MAC address of the remote device that you are trying to reach.
Press [Enter]. The Hub Console Interface displays the following prompt:
Enter in test time (1 - 15 sec):
Type the number of seconds that you want to lapse between test packets
transmitted on the primary link to verify that it continues to operate
correctly. Press [Enter]. The Hub Console Interface displays the following
prompt:
Enter in consecutive failures (1-16):
Type the number of times you will allow the port to time out during the
text packet transmissions before being disabled. Press [Enter]. The Backup
Links Screen displays the information shown in the sample screen.
Be careful not to
remove a backup link
that is the active port.