HP 10Base-T Hub 24M Manual page 127

Configuration Reference
Note that you cannot control Port Security settings from the Hub Console
Interface. You need to use the Browser Interface or ASA to set security
parameters. You can only disable security from a port, using the Hub Console
Interface.
6-70
Eavesdrop Prevention. Indicates whether packets not intended for the
port will be scrambled. The settings can be:
On. Indicates that a packet not intended for the port will be scrambled.
Off. Indicates that a packet not intended for the port will be received
by the port.
Send Alarm. Indicates whether an alarm will be sent to a log when an
incoming packet from the connected node does not match the authorized
address. The settings can be:
On. Indicates that an alarm will be sent to a log when an incoming packet
from the connected node does not match the authorized address and
Eavesdrop Prevention is enabled.
Off. Indicates that no alarm will be sent to a log when an incoming
packet from the connected node does not match the authorized address.
Disable Port. Indicates whether the port will be disabled when an
incoming packet from the connected node does not match the authorized
address. The settings can be:
On. Indicates the port will be disabled in response to it receiving an
incoming packet from the connected node that does not match the
authorized address when Eavesdrop Prevention is enabled.
Off. Indicates the port will not be disabled in response to it receiving
an incoming packet from the connected node that does not match the
authorized address.
Set Security Policy for Selected Ports Button (Browser Interface
only). Stores the security settings you have configured for ports on the
hub.