Setting Backup Links In The Browser Interface - HP 10Base-T Hub 24M Manual

Port 14 failed to
respond after two one-
second attempts by a
packet. Port 15 is now
the active port.
Figure 6-34. The Backup Links Window

Setting Backup Links in the Browser Interface

To set backup links from the Browser Interface, perform the following steps:
1. From the Tab Bar, click on the Configuration Tab. The Browser Interface
displays the Configuration Button Bar.
2. From the Configuration Button Bar, click on the Backup Links Button.The
Browser Interface displays the Backup Links Window.
3. Click on the Add New Backup Link Button. The Browser Interface
displays the Backup Links Configuration Window.
4. From the Primary Port list box, select the number of the port on the hub
for which you want to assign a backup port.
5. From the Backup Port list box, select the number of the port on the hub
that will act as the backup port when the primary port fails.
6. From the MAC Address box, type the MAC address of the remote device
to which primary and backup ports connected.
7. From the Test Time box, type the number of seconds to lapse between
packets transmitted on the primary port to verify that it continues to
operate correctly.
Configuration Reference
6-81