Table of Contents
Advertisement
Emptying the Punch Waste Container
When the finisher is installed and the hole punch waste container R4 becomes full, a message
appears on the display. When the message appears, empty the hole punch waste container as
instructed.
Important
• Empty the hole punch waste container when the machine is on.
• Make sure to discard all paper chads when emptying the hole punch waste container. Not doing so will cause
the container to fill up before the message telling you to empty the container appears again, and this can
cause machine malfunction.
Disposal procedure (for Finisher-B1)
1.
Make sure that the machine is not operating,
lift the finisher transport cover F, and then
open the front transport door G of the
finisher.
2.
Pull out the hole punch waste container.
3.
Empty the container.
4.
Insert the emptied hole punch waste
container into the finisher until it stops.
7.1 Replacing Consumables
299
Advertisement
Table of Contents
