Fuji Xerox DocuPrint C5155d User Manual page 411

5. Loosen the three screws on the control board
of the printer.
6. Pull out the handle on the control board and
then carefully pull the control board out of the
printer. Place the control board on a table top
or some other flat surface.
Important
• When pulling out the control board, hold it with both
hands so you do not drop it.
7. Widely open the tabs on each side of the R1
slot as shown in the right figure, and then
insert the TC/SC Additional Fonts Kit straight
into the R1 slot with aligning the notch in the
Kit with the concavity of the R1 slot.
Important
• The slot R1 is for other optional kit. Do not insert the TC/
SC Additional Fonts Kit.
Press the ROM card down firmly into the slot.
Note
• Make sure the ROM card is inserted securely as far as it
can go.
• When the ROM card is installed correctly, the retaining
clips on both ends stand up.
8. Reinsert the control board back into the
printer. Holding its handle, slide the control
board back into the printer.
Important
• Be sure to hold the handle when inserting the control
board. The control board may be damaged if you insert it
with the handle being folded.
screw
A.9 Installing the TC/SC Additional Fonts Kit
411