Table of Contents
Advertisement
10. Reinsert the control board back into the
printer. Holding its handle, slide the control
board back into the printer.
Important
• Be sure to hold the handle when inserting the control
board. The control board may be damaged if you insert it
with the handle being folded.
Press the control board in as far as it will go.
11. Tighten the three screws to secure the control
board in place.
Note
• Standard USB port is not available when the Gigabit
Ethernet Board Kit is installed. It is recommended to put
the sticker (included with the Gigabit Ethernet Board Kit)
on the standard USB port.
12. Connect the network cable to the interface
connector for the Gigabit Ethernet Board Kit.
13. Connect the other end of the connector for
the network cable to the network device such
as Hub.
14. Connect the power cord to the printer.
Turn on the printer's main power switch and power switch.
15. Make sure the printer's blue lamp lights up.
Gigabit Ethernet Board Kit installation is now complete.
screw
A.8 Installing the Gigabit Ethernet Board Kit
407
Advertisement
Table of Contents
