Table of Contents
Advertisement
Removing the Gigabit Ethernet Board Kit
This section describes how to remove the Gigabit Ethernet Board Kit on the printer. Refer to the
steps in the "Installing the Gigabit Ethernet Board Kit" (P. 405) above for the detailed instructions
as the similar steps are explained simply.
1.
Press the <
switch to turn off the power.
Note
• Make sure that there is no indication on the display, and
<Energy Saver> button is off.
2.
Open the front cover.
3.
Press the <
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control panel.
4.
Unplug the power cord from the power outlet
and the printer.
5.
Loosen the three screws on the control board
of the printer.
408
A Appendix
> side of the printer's power
> side of the printer's main
screw
Advertisement
Table of Contents
